裝載機氣壓表壓力上升緩慢怎么辦？

裝載機有時候會出現氣壓表壓力上升緩慢的現象，對于這個問題，很多裝載機操作者都不知道如何處理，下面永保機械的專家就給大家仔細總結一下。
Loader sometimes appear pressure rise slow phenomenon, for this problem, a lot of loader operators do not know how to deal with, the following is the expert on the mechanical and maintenance of the machinery will give you a careful summary. 

首先應排除裝載機管路漏氣，檢查氣泵工作狀態是否正常。將裝載機氣泵出氣管拆下，我們可以用大拇指壓緊氣管出氣口，若排氣壓力低，說明氣泵有故障。若裝載機氣泵工作狀態良好，再檢查油水分離器放油螺塞或調壓閥，避免旁通，通過檢查排除故障。最后再檢查裝載機三通接頭中的兩個單向閥，單向閥卡滯會造成儲氣筒不能進氣或進氣緩慢。
First of all should be excluded from the loader pipeline leak, check whether the normal work state of pump. The loader pump outlet tube removed, we can use the thumb pressing the tracheal outlet, if the exhaust pressure is low,indicating pump failure. If the loader pump in good working condition, and then check the oil-water separator drain plug or pressure regulating valve, to avoid bypass, by checking the troubleshooting. Finally, check the two one-way valve loader three pass joint of the one-way valve will cause the cylinder can not block intake or intake slowly.